MIG 190T TURBOMIG 220T TURBOMIG 260T TURBO7/97OPERATING & MAINTENANCEINSTRUCTIONS
SAFETY EQUIPMENTA comprehensive range of CLARKE safety equipment for use when welding is available from yourlocal CLARKE dealer.WELDER SPECIFICATIONST
TUNING THE WELDERThe tuning of a Mig welding machine requires some practice, due to the fact that, (contrary to the arcwelding procedure) two paramete
125. Turn the power on, open the cylinder valve, then set the gas flow to approx. 8 l/min on theregulator. Operate the torch trigger to ensure that th
SPARE PARTS LISTModel: MIG 260T Turbo (SEE DIAGRAM ON PAGE 22) Part No. 6010390Item Description Part No.1 2 oval shaped handles EM216000122 Printed ci
3Thank you for purchasing this CLARKE Mig Welder. Before attempting to operate the machine,please read this instruction manual and follow all directio
SAFETY - GENERALSpecial care is taken during all stages of manufacture to ensure that your CLARKE Mig Welderarrives with you in good condition.Before
c) computer and other control equipment;d) safety critical equipment, e.g. guarding of industrial equipment;e) pacemakers and hearing aids etc;f) equi
62.6 Screening and shieldingSelective screening and shielding of other cables and equipment in the surrounding area may alleviateproblems of interfere
7electrical parts) of metallic particles that can cause short circuits. If combustibles are in the area, doNOT weld or cut. Move the work if practicab
8filter plates must be replaced IMMEDIATELY. Replace clear cover plate when broken, pitted, orspattered. WE SUGGEST to wear flash goggles with side sh
b) Electrode holders - Fully insulated electrode holders should be used. Do NOT use holders withprotruding screws or with any form of damage.c) Connec
Komentarze do niniejszej Instrukcji