Clarke 250TE Dokumentacja Pobierz pdf (Strona 9)

LOADING WIRE

NOTE: These machines are designed to accept either 5Kg or 15Kg wire spools of

mild steel, stainless steel or aluminium according to the type of metal you wish to

weld. Wire spools ARE NOT supplied with the unit and must be purchased separately.

1 Ensure the gas and electrical supplies are disconnected;

2 (Ref. Fig. 3) Turn the plastic knob (23F), 180°.

3 Take off the plastic cover of the wire spool; FIG.3

4 To fit the wire spool (23H)

into the hub (23A) push the

button (23I), insert the wire

spool, followed by the collar

(23C)(it must be used only

with 5Kg wire spools) .

5 Turn the plastic knob (23F)

by 180° again.

6 Loosen the plastic knob by

turning it anti-clockwise,

(this maintains pressure on

the wire via the roller). Pull,

on the plastic knob, so that

the screw rod comes out

of its slot, thereby

releasing the pivoted roller

bracket. Raise the bracket

together with the pressure

roller, and pullout any wire

that has been left in the

hose.

7 If you are changing the size of wire, you must also select the appropriate groove

on the feed roller. To change to the other groove, undo the Hex. Socket Screw and

remove the roller from its shaft. Turn it through 180°, replace it on the shaft, and

adjust so that the groove is directly in line with the Wire Liner. Firmly secure it in

that position with the Hex. Socket Screw.

8 Clip the end of the wire, on the spool, cleanly, ensuring there are no burrs or sharp

edges, and, ensuring it is straight, feed it through the guide tube , over the channel

on the roller and into the wire liner, by approx. 10 - 15cm.

FACE MASK

To assemble the face mask, first place the dark glass window and the clear glass

window together in the recessed window area of the body.

IMPORTANT: the clear glass window should be placed on the outside of the

mask.

Secure in place using the screws and nuts provided. Bend the sides of the mask into

shape and fix together using the screws and nuts provided, and finally, fit the handle

to the shield body also using the screws and nuts provided.

ATTACHING THE GAS BOTTLE AND REGULATOR

1. The bottle (not supplied) should be located at the rear of the welder,

securely held in position by the chain provided.

2. For safety, and economy, ensure that the regulator is fully closed, (turned

anti-clockwise) when not welding and when fitting or removing the gas cylinder.

3. Connect the gas hose to the regulator securing with clip/nut provided.

4. Screw the gas regulator fully down on the gas bottle valve, and fully tighten.

5. Turn the power on, open the cylinder valve, then set the gas flow to approx. 8l/

min. on the regulator. Operate the torch trigger to ensure that the gas is flowing

through the torch.

TORCH LEAD ASSEMBLY INSTRUCTIONS

Plug the troch hose into the socket on the front of the welder and secure by hand

screwing in the threaded connection. FIG.2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Komentarze do niniejszej Instrukcji

Brak uwag

Clarke 250TE Dokumentacja Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla System spawalniczy Clarke 250TE