Clarke 00311C Instrukcja Operatora Pobierz pdf (Strona 10)

ENGLISH

Page -10- Form No. 71171A Clarke

Operator’s Manual (EN) - Focus Rider

BATTERY CONNECTIONS

Front of

machine

235 AH, 6 Volt

(Battery No. 881317 Wet)

(Battery No. 881318 Dry)

Three (3) 70222A Spacers

310 AH, 6 Volt

(Battery No. 56391391 Wet)

305 AH, 6 Volt

(Battery No. 891385 Dry)

420 AH, 6 Volt

(Battery No. 56388582 Wet)

375 AH, 6 Volt

(Battery No. 40602A Dry)

Front of

machine

Front of

machine

How To Prepare the Machine For Operation

How To Handle the Packed Machine

The machine is packed in a speciﬁ c package provided on a pallet so that

it can be moved with a forklift.

WARNING: The packages cannot be placed on top of

each other.

How to Unpack the Machine

1. Remove the outer package.

2. The machine is ﬁ xed on the pallet with banding straps and

wooden blocks to prevent movement during shipment. Remove

the bands and blocks.

3. The machine is shipped with the batteries already installed.

4. Remove tie down brackets.

5. Lower the ramp. The machine can be driven off of the pallet if

the operator is thoroughly familiar with its operation. Avoid violent

blows to the base unit.

6. Keep the pallet for future transport necessities.

How to Install the Batteries

WARNING: The batteries are heavy. Lifting batteries

without help could result in an injury. Get

help to lift the batteries.

WARNING: Working with batteries can be dangerous.

Always wear eye protection and protective

clothing when working near batteries. NO

SMOKING!

WARNING: Hydrogen gas is formed during the charging

operation and is explosive. Only charge bat-

teries in a well ventilated area with the seat

base lifted.

The batteries are ﬁ tted in the battery compartment under the seat and

recovery tank (ﬁ gure 3). The machine uses six - 6 volt batteries. They

must be handled by using appropriate lifting equipment suitable for the

weight and for the coupler system. For maintenance and daily recharge

of the batteries, it is necessary to follow all instructions given by the

manufacturer.

For Battery Installation follow these steps (See ﬁ gure 3):

1. Make sure that the key switch is in the “OFF” position.

2. Lift and rotate the base support of the seat forward.

3. Lean the seat on it’s restraint cable.

4. Lift the front of the recovery tank and rotate it towards the rear

until it rests on it’s restraint cable.

5. Put the batteries into position and connect the battery cables as

shown in ﬁ gure 3.

6. Rotate the recovery tank and then carefully rotate it forward to the

normal operating position.

7. Lower the base support of the seat.

NOTE: Charge the batteries before using.

Figure 3

revised 1/11

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 129 130

Komentarze do niniejszej Instrukcji

Brak uwag

Clarke 00311C Instrukcja Operatora Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płuczka Clarke 00311C