Clarke BOOST 28 Instrukcja Operatora Strona 11
- Strona / 142
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
ENGLISH
Operator’s Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
11
USE
WARNING!
On some points of the machine there are some
adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
–
–
–
–
While reading this Manual, the operator must pay particular
attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace
them if damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can
be seriously damaged if the batteries are either
improperly installed or connected. The batteries
must be installed by qualifi ed personnel only. Set
the function electronic board and the built-in battery
charger according to the type of batteries used (WET
or AGM batteries).
Check the batteries for damage before installation.
Disconnect the battery connector (A, Fig. 5) and the
battery charger plug (I).
Handle the batteries with great care.
Install the battery terminal protection caps supplied
with the machine.
The machine requires two 12 V batteries, connected according to
the diagram (A, Fig. 6).
The machine can be supplied in one of the following modes:
Batteries (WET or AGM) already installed and charged
Check that the batteries are connected to the machine with
the connector (A, Fig. 5).
Insert the ignition key (B) and turn it to "I".
If the green warning light (C) turns on, the batteries are
charged.
If the yellow (D) or red warning light (E) turns on,
the batteries must be charged (see the procedure in
Maintenance chapter).
Without batteries
Buy appropriate batteries (see the Technical Data
paragraph).
For battery choice and installation, apply to qualifi ed battery
Retailers.
Set the machine and the battery charger according to the
type of batteries (WET or AGM), as shown in the next
paragraph.
A)
1.
2.
B)
1.
2.
3.
Figure 5
Figure 6
- Form No. 9097066000 - 12/2007 1
- TABLE OF CONTENTS 2
- OPERATOR SAFETY INSTRUCTIONS 3
- INTRODUCTION 5
- TECHNICAL DATA 6
- MACHINE TRANSPORT PROCEDURES 7
- SYMBOLS SHOWN ON THE MACHINE 7
- MACHINE DESCRIPTION 8
- Operator’s Manual - FOCUS 9
- Figure 2 9
- CONTROL PANEL 10
- SETTING (WET OR AGM) 12
- BEFORE START-UP 13
- Types of brushes available 14
- II L20 Cyl.) 15
- Mixing System) 17
- MACHINE START AND STOP 18
- Machine drive controls 19
- Detergent fl ow adjustment 20
- TANK EMPTYING 21
- AFTER USING THE MACHINE 22
- MACHINE LONG INACTIVITY 22
- FIRST PERIOD OF USE 22
- MAINTENANCE 23
- SQUEEGEE CLEANING 24
- BRUSH/PAD CLEANING 26
- DETERGENT TANK CLEANING 28
- DECK DISASSEMBLY/ASSEMBLY 29
- BATTERY CHARGING 30
- MACHINE WORKING HOUR CHECK 32
- FUSE CHECK/REPLACEMENT 32
- TROUBLESHOOTING 33
- INTRODUCCIÓN 37
- DATOS TÉCNICOS 38
- PROCEDIMIENTOS PARA EL 39
- TRANSPORTE 39
- SÍMBOLOS 39
- DESCRIPCIÓN DE LA MÁQUINA 40
- Figura 2 41
- PANEL DE CONTROL 42
- LA MÁQUINA NUEVA 43
- Tipos de cepillos disponibles 46
- Parada de la máquina 50
- VACIADO DE LOS DEPÓSITOS 53
- DESPUÉS DEL USO DE LA MÁQUINA 54
- PRIMER PERIODO DE UTILIZACIÓN 54
- MANTENIMIENTO 55
- LIMPIEZA DE LA BOQUILLA 56
- LA BOQUILLA 57
- DE ASPIRACIÓN 58
- DETERGENTE/AGUA LIMPIA 58
- LA GUARNICIÓN DE LA TAPA 59
- PORTACEPILLOS/PORTAFIELTROS/ 61
- PORTACEPILLOS CILÍNDRICOS 61
- CARGA DE LAS BATERÍAS 62
- BÚSQUEDA AVERÍAS 65
- FRANÇAIS 67
- CARACTERISTIQUES TECHNIQUES 70
- PROCEDURES POUR LE TRANSPORT 71
- DESCRIPTION DE LA MACHINE 72
- TABLEAU DE BORD 74
- UTILISATION 75
- Types de brosses disponibles 78
- (seulement pour 79
- Mise en marche de la machine 82
- Arrêt de la machine 82
- VIDANGE DES RESERVOIRS 85
- ENTRETIEN 87
- SYSTEME D'ASPIRATION 90
- L'EAU PROPRE 90
- PORTE-BROSSES CYLINDRIQUES 93
- CHARGEMENT DES BATTERIES 94
- DEPISTAGE DES PANNES 97
- Parts List 99
- General View 100
- Solution Tank 102
- Solution Tank - 10/07 103
- Recovery Tank 104
- Recovery Tank - 09/07 105
- Chassis System 106
- MACHINE WITHOUT DRIVE 108
- MACHINE WITH DRIVE 108
- Wheel Systems 108
- Wheel Systems - 09/07 109
- Handle Assemblies 110
- Handle Assemblies - 09/07 111
- Solution System 112
- Solution System - 12/07 113
- Squeegee System 114
- Squeegee System - 09/07 115
- FROM 1 TO 53 = 9097150000 116
- Brush System - 09/07 117
- Parts List - FOCUS 118
- Brush System - 12/07 119
- FROM 1 TO 54 = 9097149000 120
- Brush System - 10/07 121
- FROM 1 TO 59 = 909 6854 000 122
- Accessories - 10/07 125
- Accessories 126
- Control Panel System - 09/07 128
- Chemical Mixing System 134
- Wiring Diagram FOCUS II Drive 137
- LIMITED U.S. WARRANTY 142
Powiązane produkty i podręczniki dla Płuczka Clarke BOOST 28
Płuczka Clarke 00311C Instrukcja Operatora
(130 strony)
(130 strony)
Płuczka Clarke Encore Instrukcja Operatora
(58 strony)
(58 strony)
Płuczka Clarke Encore L20 Instrukcja Operatora
(29 strony)
(29 strony)
Płuczka Clarke Alto115V Instrukcja Operatora
(20 strony)
(20 strony)
Płuczka Clarke Boost 32 Instrukcja Operatora
(102 strony)
(102 strony)
Płuczka Clarke Alto115V Instrukcja Operatora
(12 strony)
(12 strony)
Płuczka Clarke Bext-100 Instrukcja Operatora
(13 strony)
(13 strony)
Płuczka Clarke Encore L33 Instrukcja Użytkownika
(34 strony)
Płuczka Clarke Bext-150H Instrukcja Użytkownika
(20 strony)
(20 strony)
Płuczka Clarke Bext-150H Instrukcja Operatora
(27 strony)
(27 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.055 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji