Clarke 250TE Dokumentacja Pobierz pdf (Strona 11)

ADDITIONAL SAFETY PRECAUTIONS for MIG WELDING

ALWAYS ensure that there is full free air circulating around the outer casing of

the machine, and that the louvres are unobstructed.

Welding arc can seriously damage your eyes. Both operator and spectators

must ALWAYS use a proper welding face shield or helmet, with suitable filter

lenses. Proper gloves and working clothes should be worn at all times.

ALWAYS check that the pressure regulator and gauges (where fitted), are

working correctly. DO NOT lubricate the regulator.

ALWAYS use the correct regulator. Regulators are designed to be used with

a specific gases.

ALWAYS inspect the torch hose before use to ensure it is in good condition.

ALWAYS keep the free length of torch hose outside the work area.

ALWAYS remove all flammable materials from the welding area.

ALWAYS keep fire extinguisher handy....’Dry Powder, C0

or BCF, NOT Water

NEVER remove any of the panels unless the machine is disconnected from

the supply, AND never use the machine with any of the panels removed.

NEVER attempt any electrical or mechanical repair unless your are a qualified

technician. If you have a problem with the machine contact your local

CLARKE dealer.

NEVER use or store in a wet/damp environment. DO NOT EXPOSE TO RAIN.

The MIG welding process uses an INERT gas to protect the weld pool. It is

important to ensure the appropriate gas is being used. NEVER use gas from

a cylinder, the content of which is unknown.

NEVER a. Use a damaged cylinder.

b. Lift the cylinder by the valve.

c. Expose the cylinder to a heat source or sparks.

NEVER continue to weld, if, at any time, you feel even the smallest electric shock.

Stop welding IMMEDIATELY, and DO NOT attempt to use the machine until the fault

is diagnosed and corrected.

NEVER point the MIG torch at any person or animal.

NEVER touch the MIG torch nozzle until the welder is switched OFF and the

nozzle has been allowed to cool off.

NEVER connect, disconnect, or attempt to service the MIG torch, until the machine

is switched OFF and disconnected from the mains supply.

NEVER allow the earth cable or torch hose to become wrapped around the

operator or any person in the vicinity.

✔

✗

MIG 270TE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Brak uwag

Clarke 250TE Dokumentacja Strona 11