Clarke 250TE Dokumentacja Pobierz pdf (Strona 13)

MIG 220TE & 255TE

ELECTRICAL CONNECTIONS

WARNING! THIS APPLIANCE MUST BE EARTHED.

Connect the mains lead, through a suitably fused isolator switch, to a 230 Volt (50Hz)

electrical supply, having a fuse rating in accordance with that given in the specification

chart on page 2. A standard 13 Amp plug MUST NOT be used with this machine.

IMPORTANT: The wires in the mains lead are coloured in accordance with the following

code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the flexible lead of this appliance may not correspond with the

coloured markings identifying terminals in your electrical supply, proceed as follows:

• Connect GREEN & YELLOW coloured cord to terminal marked with a letter

“E” or Earth symbol “ ” or coloured GREEN or GREEN & YELLOW.

• Connect BROWN cord to terminal marked with a letter “L” or coloured RED.

• Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.

MIG 270TE

This model is designed for use with a 400V three-phase supply, and should be

connected through a suitably fused isolator switch.

The GREEN or GREEN & YELLOW wire should be connected to the EARTH terminal

or terminal marked with “ ” symbol. The other two wires are for connection to the

phase wires.

Cable Extensions:

IMPORTANT:

For extensions up to 10M, the size of the conductors MUST be at least the same size

as that used on the machine - 2.5mm

. It is NOT advised to use extensions greater

than this, but if it is absolutely necessary, the conductor size must be 4mm

up to a

maximum of 25M in length.

DANGER

NEVER OPERATE THIS MACHINE WITH THE SIDE PANELS PARTIALLY

OPENED OR COMPLETELY REMOVED

WIRING DIAGRAMS

MIG 220TE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Clarke 250TE Dokumentacja Strona 13